Sony HDW-1800 - Manual (Page 98)

98
9-4 Items in the Extended Setup Menu
Ch
apt
er 9 Set
up Men
u
s
904 FREEZE CONTROL
FROM KEY PANEL Select how the buttons used to freeze an image function.
MOMNT: Select F8 (FREEZE) in function menu page P05: MISC-2 carries out a
freeze. The freeze ends when the button is released.
LATCH: Select the F8 (FREEZE) carries out a freeze. The freeze continues even
after the button is released.
• To update the freeze image
Select F8 (FREEZE) again.
• To end the freeze
Select F9 (FREZ OFF).
905 AUTO FREEZE
CONTROL Set the auto freeze function operation (conditions for cancelling a freeze, etc.).
In dynamic tracking (DT) playback (VAR, JOG, PLAY or SHTL mode), if there is a
sudden worsening of the channel condition (entry into unrecorded area), this
function detects the sudden worsening and freezes the image.
DIS: Disable the auto freeze function.
MODE1: Automatically cancel the freeze when signals which can be normally
played back are restored.
MODE2: Automatically cancel the freeze upon start of playback after stopping.
• The automatic freeze mode is set by menu item 903.
• The freeze is ended immediately, regardless of the above settings, when this
unit is switched to any of the following modes:
Edit preset function on
Cue up
Recording
906 STOP FREEZE
CONTROL Select whether the STOP FREEZE function should operate.
DIS: Do not operate.
ENA: Operate.
stby: Operate only in standby mode.
920 SD-SDI H-ANC CONTROL
(Invalid in 24PsF or
23.98PsF mode) Select whether to add information to the SD output.
Sub-item
1 AUDIO 5CH-8CH ON: Add digital audio data CH5 to CH8.
OFF: Do not add digital audio data CH5 to CH8.
2 RP188 ATC ON: Add RP188 timecode data.
OFF: Do not add RP188 timecode data.
921 ASPECT FLAG
(Invalid in 50i, 25PsF,
24PsF or 23.98PsF mode) Select whether to add the 16:9/Squeeze ID signal provided for by ARIB TR-B17 to
the down-converted SD output when an HDCAM tape is played back. Also select
whether to switch the upconverter mode when a 16:9/Squeeze ID signal is
detected on an SD playback tape.
OFF: Do not add the 16:9/Squeeze ID signal to the SD signal down-converted from
HD.
When an SD tape is played back, the upconverter mode follows setup menu
item 950 regardless of detection of the ID signal on the tape.
ON: Add the 16:9/Squeeze ID signal to SD output down-converted from HD in
Squeeze mode.
When an SD tape is played back, automatically switch the upconverter mode
change by detecting the ID signal on the tape. If the 16:9/Squeeze ID signal is
not detected on the SD tape, the upconverter mode follows setup menu item
950.
930 DOWN CONVERTER
MODE (Invalid in 24PsF or
23.98PsF mode) Select the downconverter mode.
crop: Select the edge-crop mode.
l-box: Select the letter box mode.
squez: Select the squeeze mode.
Menu items in the range 900 to 999, relating to digital processing (Continued)
Item number Item name Settings