Sharp TINSE2026QSZZ - Manual (Page 109)

107
SYSTEM SETTINGS (ADMINISTRATOR)
6
STREAM FEEDING MODE
Use this program to enable stream feeding mode.
When this mode is enabled and originals are scanned
from the RSPF, an original can be added to the RSPF
within 5 seconds after the previous original is fed, and
be automatically scanned using the settings of the
previous original. This function can be used with the
copy function and the scanner function.
This program is initially disabled (factory default
setting).
DISPLAY LANGUAGE SETTING
This program is used to change the language used in
the display.
The factory default setting is "AMERICAN ENGLISH".
DISABLE DISPLAY TIMEOUT
When this program is disabled, the display will close
the screen that is currently open and return to the
initial screen if no keys are touched for 60 seconds.
When the program is enabled, the display will not
close the screen that is currently open.
This program is initially disabled (factory default
setting).
DISABLING OF TRAY SETTINGS
This program can be enabled to prohibit changes to
the paper tray settings in the system settings
(general).
Note that bypass tray settings will still be possible.
This program is initially disabled (factory default
setting).
DISABLING OF CLOCK ADJUSTMENT
This program can be enabled to prohibit adjustment of
the "CLOCK" setting in the system settings.
This program is initially disabled (factory default
setting).
DEVICE CONTROL
Use these programs when a peripheral device on the
machine has failed or when you wish to temporarily
disable a device. The programs can also be used to
change the function setting of a device as required by
your conditions of use.
"DEVICE CONTROL" consists of the following
programs:
● DISABLING OF DOCUMENT FEEDER
● DISABLING OF DUPLEX
● DISABLING OF STAPLER
● OUTPUT TRAYS
● DISABLING OF OFFSET
● MEMORY FOR PRINTER
● DISABLING OF CENTER TRAY COUNTING
● RETURN FROM COPY MODE TIMING
● MIX SIZE ORIGINAL FEEDING MODE
● SECURITY SETTINGS
DISABLING OF DOCUMENT FEEDER
Use this program when the RSPF is not operational or
you wish to disable the automatic feeding function.
(Originals can still be scanned using the document
glass.)
This program is initially disabled (factory default
setting).
DISABLING OF DUPLEX
Use this program when you wish to disable the
two-sided printing function or the function has failed.
When this program is enabled, only one-sided printing
is possible.This program is initially disabled (factory
default setting).
DISABLING OF STAPLER
(When a FINISHER is installed)
Use this program to disable stapling.
When this program is enabled, stapling does not take
place.This program is initially disabled (factory default
setting).
SYSTEM SETTINGS
DEVICE CONTROL
DISABLING OF DUPLEX
DISABLING OF STAPLER
DISABLING OF DOCUMENT
FEEDER
OK
1/3
MX-M310.book 107 ページ ２００９年７月６日 月曜日 午後６時５７分