Sharp TINSE2026QSZZ - Manual (Page 33)

31
2
REDUCTION/ENLARGEMENT/ZOOM
There are three ways to enlarge and reduce copies:
● Automatic ratio selection according to the paper size ........................... AUTOMATIC RATIO SELECTION (below)
● Specifying a ratio with the reduce key, enlarge key, or zoom key..................MANUAL RATIO SELECTION (p.32)
● Separately selecting vertical and horizontal ratios ........................................................... XY ZOOM copying (p.33)
Ratios that can be selected vary depending on the following conditions:
AUTOMATIC RATIO SELECTION
The ratio is automatically selected based on the original size and paper size.
1 Place the original(s). (p.23, p.24)
The original size appears in the touch panel.
2 Touch the [PAPER SELECT] key and
then select the desired paper size.
The selected key is
highlighted and the paper
selection screen closes.
3 Touch the [AUTO IMAGE] key.
A suitable ratio is
selected based on the
original size and selected
paper size. (The ratio
appears in the touch
panel.)
4 Select the number of copies and any
other desired settings, and then press
the [START] key (
).
Original position Selectable ratios
Document glass 25 to 400%
RSPF 50 to 200%
• If the original size does not appear in the
touch panel, specify the original size
manually. (p.48)
• Automatic ratio selection is not possible if
the original or paper is a non-standard
size.
If paper of the desired size is not loaded in
any of the trays, load paper of the required
size in a paper tray or in the bypass tray.
(p.19)
Note
8½x14
8½x11 PLAIN
RECYCLED
Note
• When automatic ratio selection is
selected, the [AUTO IMAGE] key is
highlighted in the main screen.
• If the original and paper are in different
orientations, the image is automatically
rotated to match the paper orientation (for
paper sizes 8-1/2" x 11" (A4) or less).
• Rotation of the image can be disabled in the
administrator settings. (See "6. SYSTEM
SETTINGS (ADMINISTRATOR)".)
• If "IMAGE IS LARGER THAN THE COPY
PAPER." appears in the touch panel, part
of the image will be cut off in the copy.
To cancel automatic ratio selection, touch
the [AUTO IMAGE] key. Automatic ratio
selection also turns off automatically when
the enlargement key, the reduction key, or a
[ZOOM] key
( / ) is touched to allow
the ratio to be selected.
Note
UT
LOGOUT
Note
MX-M310.book 31 ページ ２００９年７月６日 月曜日 午後６時５７分