Sharp TINSE2026QSZZ - Manual (Page 142)

140
PERIPHERAL DEVICES AND SUPPLIES
FINISHER (MX-FN13)
The finisher is equipped with the offset function, which offsets each set of output from the previous set.
In addition, each set of sorted output can be stapled.
Part names
The following parts can be accessed when the finisher is open.
(1) Offset tray
Stapled and offset output is delivered to this tray.
The tray is slidable. Extend the tray for large output
(11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/2" x 11"R,
7-1/4" x 10-1/2"R, A3, A4R, B4 sizes).
(2) Lever
Use this to move the finisher in order to remove a
paper misfeed, replace staples, or remove a staple
jam.
(3) Front cover
Open this cover to remove a paper misfeed, replace
staples, remove a staple jam, or remove the punch
scrap case.
(4) Staple case
This holds the staple cartridge. Pull the case out to
replace the staple cartridge or remove a staple jam.
(5) Staple case release lever
Use this to remove the staple case.
Specifications
(1)
(5) (4)
(2)
(3)
MX-FN13
Tray capacity 500 sheets (250 sheets for sizes larger than 8-1/2" x 11"R (A4R))
Paper size
Size 5-1/2" x 8-1/2" to 11" x 17" (A6R to A3)
Weight 15 lbs. to 54 lbs. (56 g/m 2 to 200 g/m 2 )
Offset 1-3/16" (30 mm) (Offset Tray)
Paper sizes that can be
stapled 11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/2" x 11", 8-1/2" x 11"R (A3, B4, A4, A4R, B5,
B5R)
Stapling capacity
8-1/2" x 11", 8-1/2" x 11"R, A4, A4R, B5, B5R:
50 sheets (21 lbs. (80 g/m
2 ))
11" x 17", 8-1/2" x 14", 8-1/2" x 13", A3, B4:
30 sheets (21 lbs. (80 g/m
2 ))
Power supply Drawn from the machine
Weight Approx. 31.8 lbs. (14.4 kg)
Dimensions
18-37/64" (W) x 18-5/32" (D) x 7-27/32" (H) (472 mm (W) x 461 mm (D) x 199 mm (H))
(Normal)
24-3/8" (W) x 18-5/32" (D) x 7-27/32" (H) (619 mm (W) x 461 mm (D) x 199 mm (H))
(Tray extended)
• As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification
changes for product improvement without prior notice. The performance specification figures indicated are
nominal values of production units and there may be some deviations from these values in individual units.
• Use caution when you turn on the power and when printing is taking place, as the offset tray may move up and
down.
Note
08.fm 140 ページ ２００９年７月８日 水曜日 午後２時２０分