Sharp TINSE2026QSZZ - Manual (Page 29)

27
COPY FUNCTIONS
2
BYPASS FEED (special paper)
The bypass tray must be used to feed special papers such as transparency film and labels. The bypass tray can also
be used to feed standard copy paper.
1 Place the original(s). (p.23, p.24)
2 Insert the paper (print face down) all
the way into the bypass tray.
For paper that can be
used in the bypass tray,
see "PAPER" (p.16).
To load paper, see
"Loading paper in the
bypass tray" (p.19).
3 Touch the [PAPER SELECT] key or
the tray in the image of the machine in
the touch panel, and select the bypass
tray.
Set the type of paper that
you loaded in the bypass
tray. (p.21)
4 Select the number of copies and any
other desired copy settings, and then
press the [START] key (
).
Shifting the starting position of copying
When copying on a special size of paper in the bypass tray, the starting position of printing can be shifted vertically
for fine adjustment of the image position. To adjust the starting position of printing, follow the steps below. This
function can only be used when feeding special sizes of paper from the bypass tray.
1 Touch the [PAPER SELECT] key and then touch the [EXTRA
IMAGE ADJUST] key on the bypass tray.
2 Use the key or key to adjust the printing position, and
then touch the [OK] key.
• The position can be adjusted from -0.5 inch to +0.5 inch in 0.02
inch increments.
• When a setting from -0.5 inch to -0.02 inch is selected, the starting
position of printing is moved to front from the standard position. When
a setting from +0.02 inch to +0.5 inch is selected, the starting position
of printing is moved to rear.
EXPOSURE
AUTO 8½x11
PAPER SELECT
100%
UT
LOGOUT
READY TO COPY.
EXTRA IMAGE ADJUST
TO FRONT TO REAR
OK
0
(-0.5 0.5)
inch 0.00
MX-M310.book 27 ページ ２００９年７月６日 月曜日 午後６時５７分