Sharp TINSE2026QSZZ - Manual (Page 40)

38
CONVENIENT COPY FUNCTIONS
STAPLE SORT
(when the finisher (MX-FN13) is installed)
This function collates the copies, staples each set, and delivers the sets to the offset tray. The staple sort function
can only be used when a finisher is installed.
ORIENTATION OF THE ORIGINAL AND STAPLING
POSITIONS
Using the RSPF
Insert the originals face up.
Using the document glass
Place each original face down.
When copying 8-1/2" x 14" or 11" x 17" (B4 or A3) vertically oriented originals, the copies will be stapled at the
position shown below.
Stapling position
Top left corner
Portrait orientation Landscape orientation
Available paper sizes:
8-1/2" x 11" (A4, B5)
Stapling capacity:
For each size, up to 50 sheets
can be stapled. Available paper sizes:
11" x 17", 8-1/2" x 14",
8-1/2" x 13", 8-1/2" x 11" R
(A3, B4, A4R, B5R)
Stapling capacity:
11" x 17", 8-1/2" x 14",
8-1/2" x 13" (A3, B4)
For each size, up to 30 sheets
can be stapled.
8-1/2" x 11"R, (A4R, B5R)
For each size, up to 50 sheets
can be stapled.
Stapling position Stapling position
• When using letterhead paper in the staple sort, load the paper with the letterhead to
the front or to the right as shown in the diagram.
• When the staple sort is used, the automatic original image rotation function does not operate.
• Different sized originals cannot be copied on the corresponding sizes of paper.
• The staple sort function cannot be used if disabled in the administrator settings. (See "6. SYSTEM SETTINGS
(ADMINISTRATOR).)
• The offset function (p.36) cannot be used.
RSPF
Stapling position
Document glass
Stapling position
Note
SHARP
SHARP
03.fm 38 ページ ２００９年７月８日 水曜日 午後２時４分