Sharp TINSE2026QSZZ User Manual
Page 41
39
CONVENIENT COPY FUNCTIONS
3
1
Place the original(s). (p.23, p.24)
2
Touch the [OUTPUT] key.
3
Touch the [STAPLE SORT] key.
When the [STAPLE
SORT] key is selected,
the offset tray is
automatically selected as
the output tray. The top
tray and center tray
cannot be used.
4
Touch the [OK] key.
5
Select the number of copies and other
copy settings, and then press the
[START] key (
).
6
[When using the RSPF:]
Copying will start after all originals have been
scanned.
[When using the document glass:]
Replace the original with the next original and
press the [START] key ( ). Repeat this step until
all originals have been scanned, and then touch
the [READ-END] key.
If the memory becomes full while scanning the
originals, "MEMORY IS FULL. PRESS [START] TO
BEGIN COPYING OR [CA] TO CANCEL." will appear.
To copy only the originals that have been scanned,
press the [START] key ( ). To cancel the job, press
the [CLEAR ALL] key ( ).
2-SIDED COPY
OUTPUT
The number of originals that can be scanned
into memory can be increased by increasing
the memory allocation in the administrator
settings, or by installing more memory. (See
"6. SYSTEM SETTINGS (ADMINISTRATOR).)
READ-END
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
Note
MX-M310.book 39 ページ ２００９年７月６日 月曜日 午後６時５７分