Sharp TINSE2026QSZZ - Manual (Page 138)

136
TROUBLESHOOTING AND MAINTENANCE
Removing staple jams
Follow the steps below to remove a staple jam.
1 Open the cover.
2 While pressing the lever over to the
left, slide the finisher to the left until it
stops.
Gently slide the finisher
until it stops.
3 Lower the staple case release lever
and remove the staple case.
Pull the staple case out
to the right.
4 Raise the lever at the front end of the
staple case and remove the jammed
staple.
Remove the leading
staple if it is bent. If bent
staples remain, a staple
jam will occur again.
5 Lower the lever at the front end of the
staple case.
6 Replace the staple case.
Push the staple case in
until it clicks into place.
7 Slide the finisher back to the right.
Gently slide the finisher
back to the right until it
locks into its original
position.
8 Close the cover.
Gently slide the finisher
back to the right until it
locks into its original
position.
Take care that a bent staple does not hurt
you. Caution
07.fm 136 ページ ２００９年７月８日 水曜日 午後５時３２分