Sharp TINSE2026QSZZ - Manual (Page 112)

110
PROGRAMS FOR COPY MODE
This chapter explains the administrator settings that are used for copy mode.
COPY SETTINGS
"COPY SETTINGS" consists of the following
programs:
● INITIAL STATUS SETTINGS
● ROTATION COPY SETTING
● EXPOSURE ADJUSTMENT
● AUTO PAPER SELECTION SETTING
● SETTING A MAXIMUM NUMBER OF COPIES
● SORT AUTO SELECT
● DISABLING DELETION OF JOB PROGRAMS
● CARD SHOT SETTINGS
INITIAL STATUS SETTINGS
The copy settings revert to the default settings when
the power switch is turned on, when the [CLEAR ALL]
key ( ) is pressed, or when the auto clear time
elapses. This program is used to change the default
settings, or return changed default settings to the initial
factory default settings.
Defaults for the following copy settings can be
changed:
• Paper tray • Exposure mode
• Copy ratio • Duplex function
• Post-processing functions* (non-sort, sort, staple
sort, and group)
*Settings for the post-processing functions vary
depending on whether or not a FINISHER is
installed.
ROTATION COPY SETTING
When this program is enabled, the original image is
automatically rotated 90 degrees in the event that the
original and the paper are in different orientations.
(Rotation can only take place when auto paper
selection and automatic ratio selection are used.)
This program is initially enabled (factory default
setting).
EXPOSURE ADJUSTMENT
This program is used to adjust the exposure level
when "Auto" is used for the copy exposure.
The auto exposure level can be set separately for the
document glass and RSPF.
[1] is the lightest level and [5] is the darkest level.
The factory default settings are as follows:
• Document glass: 3
• Document feeder: 3
AUTO PAPER SELECTION SETTING
This program is used to select the paper type* that is
used when the automatic paper selection function
operates. "PLAIN PAPER" or "PLAIN AND RECYCLE
PAPER" can be selected. Auto paper selection can
also be disabled with this program.
The factory default setting is "PLAIN PAPER".
* The paper type set for each tray in the tray settings of
the system settings (general). (See "5. SYSTEM
SETTINGS (GENERAL)".)
SETTING A MAXIMUM NUMBER OF
COPIES
This program is used to set the maximum number of
copies that are allowed per original.
Any number from 1 to 999 can be set for the
maximum.
The factory default setting is "999".
SORT AUTO SELECT
This program can be used to disable automatic
selection of the sort function.
This program is initially enabled (factory default
setting).
DISABLING DELETION OF JOB
PROGRAMS
This program is used to prevent copy settings stored in
job programs from being changed or deleted.
This program is initially disabled (factory default
setting).
CARD SHOT SETTINGS
This program is used to set the initial original card size
for the card shot function. Entry of the X dimension
(width) is initially selected. Touch the keys to enter the
Y dimension (length) in the same way. To have "FIT
TO PAGE" be initially selected when the card shot
screen is opened, touch the [FIT TO PAGE] key.
If this program is used to change the default
setting for the duplex function to other than
"one-sided"
"one-sided" and the RSPF
fails or is disabled, the setting will revert to
"one-sided"
"one-sided".
* DISABLING OF DOCUMENT FEEDER (p.107)
DISABLING OF DUPLEX (p.107)
SYSTEM SETTINGS
COPY FUNCTION SETTINGS
ROTATION COPY SETTING
INITIAL STATUS SETTINGS
EXPOSURE ADJUSTMENT
OK
1/3
AE:3
AE:3
Note
MX-M310.book 110 ページ ２００９年７月６日 月曜日 午後６時５７分