Sharp TINSE2026QSZZ - Manual (Page 39)

37
CONVENIENT COPY FUNCTIONS
3
1 Place the originals in the RSPF or on
the document glass. (p.23, p.24)
If originals are placed in
the RSPF, the sort
function is automatically
selected. (To disable this
function, see the "6.
SYSTEM SETTINGS
(ADMINISTRATOR)".)
Example: 5 sets of copies or 5 copies per page of 3
originals
2 Touch the [OUTPUT] key.
3 Touch the [SORT] or [GROUP] key.
4 Touch the output tray that you wish to
use.
The output tray can only
be selected when a job
separator or finisher is
installed.
5 Touch the [OK] key.
6 Select the number of copies and any
other desired copy settings, and then
press the [START] key (
).
7 [When using the RSPF:]
Copying will start after all the originals are
scanned.
[When using the document glass:]
Replace the original with the next original and
press the [START] key ( ). Repeat this step until
all originals have been scanned, and then touch
the [READ-END] key.
The copies are grouped as follows:
If the memory becomes full while scanning the
originals, "MEMORY IS FULL. PRESS [START] TO
BEGIN COPYING OR [CA] TO CANCEL." will appear.
To copy only the originals that have been scanned,
press the [START] key ( ) . To cancel the job, press
the [CLEAR ALL] key ( ). To enable the offset function (p.36), touch the
[OFFSET] checkbox so that a checkmark
appears. To disable the offset function, touch
the [OFFSET] checkbox again to clear the
checkmark.
Originals
2-SIDED COPY
OUTPUT
UPPER
TRAY
CENTER
TRAY
Note
The number of originals that can be scanned into
memory can be increased by increasing the
memory allocation in the administrator settings, or
by installing more memory. (See "6. SYSTEM
SETTINGS (ADMINISTRATOR)".)
OFFSET
OK
UT
LOGOUT
READ-END
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
Copy
5 sets of copies 5 copies per page
Copy
Sort Group
Note
MX-M310.book 37 ページ ２００９年７月６日 月曜日 午後６時５７分