Threading the machine – SINGER 10 User Manual

Page 16

background image

5, 6, 8, 10 Stitch Sewing Machines

Threading the machine

To thread your machine correctly, follow the steps

* Raise take-up lever (6) to highest position by turning
hand wheel toward you.

* Raise presser foot to release thread tension.

* Place spool of thread on spool pin (1).

* Slide spool cap (2) firmly over rim of spool to prevent
thread tangling.

* Lead thread from spool and snap into thread guide

and with only one hand pass the thread under the
guide and through the slot, as illustrated (4).

* Thread the tension discs by leading the thread down
and around the tension (5). Hold the spool lightly and
pull the thread up, lifting the spring and allowing the
thread to slip into thread guard.

* Slip thread into take-up lever as illustrated (6).

* Pass thread through guides (7) and (8).

* Thread needle from front to back, pulling 4" (10 cm)
of thread through eye.


This manual is related to the following products: