Removing and replacing the bobbin case, Caring for your machine – SINGER 10 User Manual

Page 41

Advertising
background image

5, 6, 8, 10 Stitch Sewing Machine

8

Caring for your machine

Removing and replacing bobbin case

Caution: Before cleaning or adjusting the machine,
remove plug from the socket outlet.

* Raise presser foot and needle.

* Open slide plate, remove bobbin and remove needle
plate.

To remove bobbin case

* With a small screwdriver, turn bobbin case holder (1)
to the rear as far as it will go.

* Lifting the left side of the bobbin case, slide it out
from machine.

To replace bobbin case

* Guide forked end (2) of bobbin case under feed (3).

* Draw rim of bobbin case under position plate (4). Be
sure bobbin case is freely seated on hook race.

* Turn bobbin case holder (1 ) forward as tar as it will
go, locking bobbin case in place.

Note: Turn handwheel towards you to check to make
sure it is properly replaced.

* Replace needle plate.

* Insert bobbin and close slide plate.

41

Advertising
This manual is related to the following products: