Sharp MD-MT16H User Manual
Rechargeable battery power
When the rechargeable battery is used for
the first time or when you want to use it
after a long period of disuse, be sure to
charge it fully.
Open the battery cover.
Slide the battery cover as far as it will
go to the outside and then lift to open it.
If the battery cover is lifted without be-
ing slid all the way out, it may break.
Insert the rechargeable battery according to
the polarity marked on the bottom of the unit.
Close the battery cover.
Plug the AC adaptor into the AC socket,
and then insert the plug on the AC
adaptor lead into the DC IN 5V socket.
Press the CHARGE button to begin
” will appear, and the battery
will begin charging.
After about 4 hours have passed,
” will go out.
This indicates that the battery
charging is about 90% complete.
To charge the battery fully, continue
charging for about 2 more hours.
(In this case, you do not need to press
the CHARGE button. Even if the
CHARGE button is pressed, “
will not appear.)
After charging has been completed, the
AC adaptor may be left connected.
(For example, when charging at night)
The battery will not be charged when the
power to the main unit is turned on.
Do not force open the battery cover too wide.
Do not use a rechargeable battery or an
AC adaptor other than those specified
on page 3 (OPTIONAL ACCESSORIES).
The charging time will vary, depending
on the condition of the battery.
When the battery is charged for the first
time or is charged after not being used
for a long period, the operating time may
be shorter than normal. The battery life
will recover with normal use i.e. charg-
ing and discharging.
To avoid shortening the service life of the
battery only recharge the battery after
in has been completely discharged.
all the way in.
To the DC IN 5V socket
* MD-MT16H FOR UK(01-21)
99.4.2, 0:56 PM