Sanyo PLC HF10000L - Manual (Page 17)

17
Installation
Lens Installation
Before setting up the projector, install Projection Lens on the projector.
Before installation, check where the projector is used and prepare a suitable lens. For the specifications of
Projection Lens, contact sales dealer where you purchased the projector.
- Do not use the optional lens below for this projector. Otherwise damages may result.
LENS MODEL NO. : LNS-T01, LNS-T01Z
- Lens installation and replacement should be performed by the qualified service personnel.
- When setting the projector after lens installation, be sure to replace a Lens Cap to protect a
surface.
- When carrying or holding up the projector, be careful not to put your hands on lens part. It may
damage lens, cabinet, or mechanical parts.
Attaching the Strap
Connect the lens mount cover and the projector with the
strap (supplied) to prevent the lens mount cover from
falling down.
Fig. 1
Fig. 
Label
Matchmark (dot) on the cabinet
Matchmark (dot) on the lens mount
cover
Strap
Remove the screw. (See Fig. 1)
Turn the lens mount cover counter-clockwise.
(See Fig. 1)
1
2
Thread one end of the strap through the loop hole
on the lens mount cover. (See Fig. 2)
3
5
Fig. 
Strap
Lens Mount Cover
Screw
Fix the other end of the strap to the projector
with the removed screw. (See Fig. 3)
4
✔
Note:
• The screw which is packed with the strap is not for use
with this projector.
Lens Mount Cover
Loop Hole
Fit the lens mount cover, align the matchmark on the lens mount
cover with the left edge of the label on the cabinet, and then turn
the lens mount cover clockwise until it clicks. (See Fig.3)
Screw