Sanyo PLC HF10000L - Manual (Page 61)

61
Settings
You can replace the filter with this function. Press the SELECT
button at Filter control to display a confirmation box. To replace,
press the SELECT button at Yes and the electrically operated filter
starts to scroll.
✔
Note
• Filter replacement icon and Please wait... message appear on
the screen when the filter is being scrolled.
• The filter cannot be rewound.
• When the filter is replaced, the total accumulated time of the
filter use is automatically set to 0.
A confirmation box appears and then select Yes.
Choose the running speed of cooling fans from the following
options.
Normal ..... Operate s in this mode under normal conditions.
Max.......... Use this mode when you want to increase the
cooling effect when operating the projector in
high ambient temperature environment. Fan
noise is louder than Normal.
The eight different remote control codes (Code 1-Code 8) are
assigned to the projector; the factory-set, initial code (Code 1)
and the other seven codes (Code 2 to Code 8).
The same code should be set on both the projector and the
remote control. For example, operating the projector in Code
7, the remote control code also must be switched to Code 7.
To change the code for the projector:
Select a remote control code in this Setting Menu.
To change the code for the remote control:
Press and hold the MENU button and a number button (1-8)
on the remote control for more than five seconds to switch
between the codes. See “Remote Control Codes” on page
16.
✔
Note
• When different codes are set on the projector and on the remote
control, any operation cannot be made. In that case, switch the
code on the remote control to fit the code on the projector.
• If the batteries are removed from the remote control for a long
period of time, the remote control code will be reset.
Select a location of the infrared remote receiver of the
remote control. See “Remote Control Receivers and
Operating Range” on page 15 for details.
Both ......... Activates both the front and back receiver.
Front ........ Activates only the front receiver.
Back ......... Activates only the back receiver.
Filter control
Fan control
Remote control
RC sensor