Sanyo PLC HF10000L - Manual (Page 49)

49
✔
Note
• When White balance Red, Green or Blue is adjusted, the
Color temp. level will change to Adj..
• Tint cannot be selected when the video system is PAL,
SECAM , PAL-M or PAL-N (p.46).
Press the Point 7 button to lighten red/green/blue tone
of the black level of an image; press the Point 8 button to
deepen red/green/blue tone of the black level of an image
(from 0 to 63).
Use the Point 7 8 buttons to select the desired Auto picture
control option (Off, L1 or L2).
Off . . . . Auto picture control OFF position.
L1 . . . . . Auto picture control LEVEL 1 position.
L2 . . . . . Auto picture control LEVEL 2 position.
Use the Point 7 8 buttons to select the advanced color mode.
Off . . . . Advanced color mode is “Off”.
Auto . . . Advanced color according to the type of image.
*This function controls the operation of the Color Control
Device, which independently and automatically regulates the
amount of yellow light passing through the LCD panel, to
accurately reproduce both image color and image brightness.
Normally leave Auto (default setting).
✔ Note:
• White balance may change depending on the image.
Video Input
Auto picture control
Advanced color*
Sharpness
Gamma
Offset (Red/Green/Blue)
Use the Point 7 8 buttons to adjust the gamma value to
obtain a better balance of contrast (from 0 to 15).
Press the Point 7 button to decrease the sharpness of the
image; press the Point 8 button to increase the sharpness
of the image (from 0 to 31).