Sanyo PLC HF10000L - Manual (Page 33)


WHEN SELECTING INPUT  (5 BNC INPUT jACKS )
INPUT MENU
When your computer is connected to the INPUT 1
(ANALOG) terminal, select RGB (PC analog).
RGB(PC analog)
✔
Note:
• Input source changes if the INPUT 1 button on the remote
control is pressed.
When connecting the computer output [5 BNC Type (Green,
Blue, Red, Horiz. Sync, and Vert. Sync.)] from the computer
to G, B, R, H/HV, and V jacks:
When your computer is connected to the INPUT 2 (5
BNC INPUT JACKS) terminal, select RGB.
RGB
1


Press the MENU button to display the On-Screen
Menu. Use the Point ed buttons to select Input and
then press the Point 8 or the SELECT button.
Use the Point ed buttons to select the desired input
and then press the Point 8 button to access the
submenu items.
Use the Point ed buttons to select the desired
source and then press the SELECT button.
INPUT  MENU
Computer Input Source Selection
Menu Operation
Input Selection
WHEN SELECTING INPUT 1
(COMPUTER INPUT TERMINALS )
✔ Note:
• “Input 3” and/or “Input 4” are selectable only when interface
board(s) are connected to either or both of the slots.