Sharp AR-275 - Manual (Page 107)

FINISHER (AR-FN5)
105
6
OP
T
IO
N
AL E
Q
UIP
M
E
N
T
Finisher functions
When the finisher is installed, the following four output modes can be selected: sort, staple sort, group,
and non-sort.
Press the OUTPUT key, use the and keys (or the OUTPUT key) to select the desired output mode,
and then press the OK key. When copying in the sort or group mode, the output tray can be selected
using the and keys and pressing the OK key.
● When an SPF or RSPF is used for copying, the sort mode will be selected as the default setting.
When the platen glass is used for copying, the non-sort mode will be selected as the default setting.
Sort mode
Each set of copies will be sequentially delivered. Each collated set of copies will be stacked offset from
the previous set unless the offset stack function is disabled.
Group mode
All copies of the same original will be grouped. Copies will be offset and stacked in groups of multiple
copies from the same original unless the offset stack function is disabled.
Staple sort mode
Collated sets of copies will be stapled and delivered to the offset tray but will not be offset.
● See the next page for details.
● The bypass tray cannot be used in the staple sort mode.
Non-sort mode
All copies will be delivered without any of the finishing described above and without being offset.
1
2
3
3
2
1
3
2
1
3
2
1
1
2
3
3
3
2
3
2
1
1
1
2
1
2
3
2
3
1
2
3
1
2
3
1