Sharp AR-275 - Manual (Page 96)

SINGLE PASS FEEDER (AR-SP4)/REVERSING SINGLE PASS FEEDER (AR-RP3)
94
OP
T
IO
N
AL E
Q
UIP
M
E
N
T
Specifications
NOTE:
As a part of our policy of continuous improvement, SHARP reserves the right to make design and
specification changes for product improvement without prior notice. The performance
specification figures indicated are nominal values of production units and there may be some
deviations from these values in individual units.
Acceptable originals
Up to 30 originals ranging from 5-1/2" x 8-1/2" to 11" x 17" and from 15 lbs. to 23 lbs. can be used.
The total aggregate thickness must not exceed 5/32".
NOTES:
● Be sure to remove any staples or paper clips from the originals.
● Before placing curled or wavy originals into the document feeder tray, be sure to flatten them. If
not, original misfeeds may result.
● For best feeding of originals which have binding holes punched into them, insert them so that
the holes are positioned to the right or along the original guides. In this case the settings for
margin shift may need to be changed. See page 45.
Unacceptable originals
The following types of paper cannot be used as originals:
● Special papers including transparency film, photographs, and tracing paper
● Damaged or crumpled originals
● Paper with multiple punched holes (paper with two or three holes can be used)
● 5-1/2" x 8-1/2" size originals cannot be used in the 2-sided to 1-sided or 2-sided to 2-sided mode.
Acceptable originals Weight 15 to 23 lbs.
Size 5-1/2" x 8-1/2"* to 11" x 17"
* 5-1/2" x 8-1/2" size originals cannot be used in the duplex
copy mode.
Capacity Up to 30 sheets provided the total aggregate thickness does
not exceed 5/32"
Power supply Drawn from the copier
Detectable original
sizes 5-1/2" x 8-1/2", 8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 14", 11" x 17"
Weight SPF Approx. 11.1 lbs. (5.0 kg)
RSPF Approx. 11.9 lbs. (5.4 kg)
Dimensions 22-61/64" (W) x 17-1/8" (D) x 5-1/4" (H)
(583 mm (W) x 435 mm (D) x 133 mm (H))