Sharp AR-275 - Manual (Page 68)

66
COP
IE
R
TROUBLE
?
STATUS MESSAGES
If any of the following messages appears in the display, carry out the prescribed remedy.
Message Remedy
(Maintenance icon)
Maintenance required
soon.
Service by an authorized SHARP service technician will be
required soon. Contact your service center as soon as
possible.(This message will be displayed if the information key
is pressed when the information (
) icon is displayed.)
Maintenance required.
Call for service.
Normal maintenance service by an authorized SHARP service
technician is needed. Contact your service center.
Call for service. A malfunction has occurred which cannot be corrected by the
key operator. Contact your authorized SHARP service center
for service.
(Toner cartridge
replacement required icon)
Toner is low.
Replacement of the toner cartridge will be needed soon. (This
message will be displayed if the information key is pressed
when the information (
) icon is displayed.) See page 82.
Check the toner cartridge. Check to see if the toner cartridge has been installed properly.
Can not continue.
Remove paper from the
center tray.
The number of copies on the center tray has reached the limit.
Remove the copies from the center tray.
Please check paper in paper
tray<
✼>.
Check to see if copy paper has been loaded properly.
Load < ✼✼> paper into
tray < ✼>. Or cancel job and
change the paper size setting.
The paper size specified for the tray is different from the actual
size. See page 78.
Selected paper tray is out of
service. Contact your authorized SHARP service center for service.
Check stapler or staple jam. Staples become jammed or the staple box is not installed
properly (when an optional finisher is installed). Check the
staple box. See page 110 for staple jam removal. If the trouble
cannot be easily remedied, use key operator program
"DISABLE STAPLER" to prevent the use of the stapler until it
can be repaired. Contact your authorized SHARP service
center for service.
★ KEY OPERATOR See page 19 of the KEY OPERATOR'S
GUIDE for enabling/disabling stapler.
Please remove paper
from the stapler compiler.
Paper is left in the stapler compiler. Remove it. See page 112.
< ✼>: paper tray number
< ✼✼>: paper size to be set