Sharp AR-275 - Manual (Page 109)

FINISHER (AR-FN5)
107
6
OP
T
IO
N
AL E
Q
UIP
M
E
N
T
3 Use the and keys to select "STAPLE SORT" and press the OK key.
● Also the OUTPUT key can be used to select an output mode.
4 Set the number of copies and press the START key.
5 Replace the scanned original with the next original and press the
START key after it lights up. Repeat this step until all originals have
been scanned.
6 After all originals have been scanned, press the READ-END key.
● Copying will start and each set of completed copies will be automatically stapled and
delivered to the offset tray.
● If the message "Can not continue. Remove paper from the offset tray." appears in the
display, remove the copies from the offset tray.