Sharp AR-275 - Manual (Page 38)

36
MA
KING COP
IE
S
BYPASS FEED (special
paper)
The bypass tray must be used to feed special papers such as transparency film and labels but can also
be used to feed standard copy paper.
Acceptable paper for copying from the bypass
tray
* For paper weighing from 28 to 34 lbs., 8-1/2" x 11" is the maximum size that can be fed through the
bypass tray.
**Do not use envelopes that have metal clasps, plastic snappers, string closures, windows, linings, self-
adhesive patches or synthetic materials. These will cause physical damage to the copier.
● For best results, use only paper recommended by SHARP.
● Special papers except SHARP recommended transparency film, labels, and envelopes must be fed
one sheet at a time through the bypass tray. Up to 40 sheets of SHARP recommended transparency
film and labels can be set at one time. Up to 5 envelopes can be set at one time.
● When feeding two or three hole prepunched paper, load the paper so that the punched edge is not
positioned in the feed slot.
Copying from the bypass tray
1 Unfold the bypass tray.
● When feeding 8-1/2" x 11"R, 8-1/2" x 14" or 11" x 17" sized paper, extend the bypass tray
to support the paper.
Size Weight Capacity (21 lb. bond
paper) Special paper
Ordinary paper: 5-1/2" x 8-1/2"
to 11" x 17" 14 lbs. to 34 lbs.*
(Ordinary paper) 100 sheets Transparency
film, labels,
envelopes**
Envelopes: Commercial 10
(4-1/8" x 9-1/2"), International
DL (110 x 220 mm),
International C5 (162 x 229
mm)