Konica Minolta 7222 - Manual (Page 206)

Repeating Automatically or Selecting Repeating Times (Repeat:
AUTO/ Repeat Mode) (continued)
9-36
5.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
6.
Select the desired magnification and paper size.
• APS and AMS are automatically released, and 1.00 (100%) is selected as a
magnification ratio.
• When 2 Repeat, 4 Repeat, or 8 Repeat is selected, the scanning area will
be a portion of the selected paper size equally divided according to the
selected mode.
In this case, magnification ratio will be fixed to 1.00 (100%).
• Copy mode is automatically set to 1-1. When selecting 1-2 mode, Platen
store mode will function automatically.
7.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
8.
Position original.
For AUTO mode original, open the document feeder or platen cover, then position the
original FACE DOWN on the platen glass.
For 2 Repeat, 4 Repeat or 8 Repeat mode original, RADF is also available.
See the illustration on p. 9-34 for details.
When AUTO mode is selected, Non-Image Area Erase functions automatically.
DO NOT close the document feeder or platen cover.
9.
Press [START].
When the finisher / inner / paper exit tray capacity is exceeded due to
the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
The AUTO mode may not operate properly if lighting is directly over the platen
glass. In this case, consult your service representative about an appropriate
place for installation.