Konica Minolta 7222 - Manual (Page 276)

[2] Copier Initial (continued)
13-12
Procedure
1 Touch 2. Copier Initial to display the Copier Initial Setting Menu Screen, then touch 5.
Output to display the Output Mode Initial Setting Screen.
2 For the machine with FS-113 Finisher, perform the following operation and proceed to step
6.
To select the exit tray, touch MAIN TRAY or SUB TRAY.
NOTE:
Select MAIN TRAY to specify the Sort or Staple-sort mode.
To select the Output mode, touch SORT or GROUP.
To use the Staple mode, touch STAPLE.
NOTES:
1. If STAPLE is selected, SORT is automatically highlighted.
2. If selecting Non-sort mode, do not highlight any of the SORT, GROUP, or
STAPLE.
To select the desired staple location, touch STAPLE SET. Touch the desired location on the
Staple Location Initial Setting popup menu, and touch OK.
To use the Punch mode, touch PUNCH.
To select the desired punch position, touch PUNCH under the STAPLE SET key. Touch the
desired punch position on the Punch Position Initial Setting popup menu, and touch OK.
If desired, touch SORT, GROUP, or STAPLE to use one of these modes along with the
Punch mode.
3 For the machine with FS-114 Finisher, perform the following operation and proceed to step
6.
To select the exit tray, touch the desired tray key in the EXIT area.
NOTE:
Select Saddle Tray to specify the Fold or Fold&Stitch mode.
To select the Output mode, touch SORT or GROUP.
To use the Staple mode, touch STAPLE.
Output Mode Initial Setting Screen
(machine without Finisher) Output Mode Initial Setting Screen
(machine with IT-101)
Staple Location Initial Setting popup menu Punch Position Initial Setting popup menu