Kyocera FS-3700 - Manual (Page 18)

1.7. Memory Expansion Installation
In this section is explained how to expand the printer’s memory. Expanded printer memory en-
ables you to print more complex pages, download more fonts, and define more macros.
It begins by explaining how to remove the main circuit board from the printer, and explains
how to install a SIMM (single in-line memory module) on the main circuit board.
*
The expansion memory should be installed only by a Kyocera authorized
dealer or Kyocera certified technician. Kyocera shall not be liable for damage
due to improper installation of the expansion memory.
The minimum memory requirements for the printer with various options installed are listed in
the table below. Please refer to this table when expanding the printer’s memory.
Printing condition
Resolution
300 dpi 600 dpi
HP LaserJet 4 Plus only 2 MB 2 MB
HP LaserJet 4 Plus, duplex mode = on 2 MB 3 MB
HP LaserJet 4 Plus/KPDL, duplex mode = None 2 MB 3 MB
HP LaserJet 4 Plus/KPDL, duplex mode = on 3 MB 5 MB
HP LaserJet 4 Plus/KPDL, resource protection,
duplex mode = None,
- 10 MB
HP LaserJet 4 Plus/KPDL, resource protection,
duplex mode = on,
- 14 MB
Removing the Main Circuit Board
The main circuit board of the printer is equipped with two sockets for memory expansion. Ex-
pansion memory is available in the form of a SIMM.
*
The following instructions are intended for the technician only.
Notes on Handling the Main Circuit Board and SIMM
Protect the electronics by taking these precautions:
F
Before touching the main circuit board, touch a water pipe or other large metal object
to discharge yourself of static electricity. While doing the work, it is recommended
that you wear an antistatic wrist strap.
F
Touch the main circuit board and SIMM only by the edges.
1.7. Memory Expansion Installation
1-23