Kyocera FS-3700 - Manual (Page 22)

Testing the Expansion Memory
After you have finished installing SIMMs in the printer, test the printer to see if the installation
has been successful.
To test the expansion memory, proceed as follows:
1. Make sure the power switch is off. Plug the power cord into the printer and turn power
on.
2. When the printer is on-line, press the STATUS key.
3. If the installation has been successful, the Total memory (Memory Allocation) of the
status page will show the expanded memory size corresponding to the amount of mem-
ory added. (The factory installed memory size is 2 MB.)
1.7. Memory Expansion Installation
1-27