Kyocera FS-3700 - Manual (Page 79)

5.2. Power Problems
*
The printer power rating must be within the voltage range in your country. If
in doubt, consult your dealer.
If nothing happens when you switch the printer’s power on, you have a power problem. The
symptoms are a dark control panel, no printing, and no fan sound. Proceed as follows.
Check the power switch.
The on position is marked "| ".
The off position is marked "
š "
Check the power cord.
If the cord is loose at either end, switch power off, plug the power cord in securely, then
switch power on again.
Call for the assistance of a service person.
If the above checks do not solve the problem, call for the assistance of a service person.
5.3. Interface Problems
If the printer prints a status page correctly but does not print data from the computer correctly
(or at all), there may be an interface problem.
Check the interface (network) cable.
Make sure the cable is plugged in securely at both ends.
Check your file and software.
Try printing a different file, or using a different print command.
Try using a different cable.
Compare the pin assignments listed in Appendix C with the specifications of your cable.
Call for the assistance of a service person.
If the above checks do not solve the problem, call for the assistance of a service person.
5.2. Power Problems
5-2