Kyocera FS-3700 - Manual (Page 81)

Dropouts, horizontal streaks, stray dots
Clean the charger wire.
Open the printer side cover. Pull the green main charger wire cleaning knob slowly in and out
a few times. See Section 4.2.
Note the spacing of the defects.
If the defects occur at regular intervals of 60.6 mm (2.4 inches), the problem may be a dirty
transfer roller. Call for the assistance of a service person.
If the defects occur at regular intervals of 94 mm (3.7 inches), the problem may be a damaged
drum unit or fuser roller. Call for the assistance of a service person.
Black or white vertical streaks
Check the control panel.
If the
Toner low TK-20 Clean printer message is displayed and the in-
dicator is flashing, install a new toner kit. See Section 4.1.
Clean the charger wire.
Open the printer side cover. Pull the green main charger wire cleaning knob slowly in and out
a few times. See Section 4.2.
Call for the assistance of a service person.
If the above checks do not solve the problem, call for the assistance of a service person.
5.4. Print Quality Problems
5-4