Kyocera FS-3700 - Manual (Page 72)

5. The bottom of the toner container is
sealed with a plastic strip. Carefully pull
the sealing strip off the toner container,
making sure not to leak any toner. Dis-
pose of the sealing strip.
6. Install the toner container on the devel-
oper as shown in the diagram.
☛
Be sure to peel off the seal on the
toner container before mounting the
toner container on the developer
unit.
7. When the toner container is installed cor-
rectly on the developer.
8. Push the top of the toner container unit
("
PUSH HERE") until it locks in.
☛
Make sure that the toner container is
properly locked in the printer.
9. Close the top cover by pressing the ar-
rowed part in this diagram.
☛
It is necessary to clean the inside of
the printer after replacing the toner
container.
If the toner container is replaced when the message
Replace Toner
Clean printer is displayed, the message Clean printer
..press CONT will be displayed after replacement. After cleaning the in-
side of the printer (See Section 4.2. Cleaning), the message will disappear
when the
CONT key is pressed, and the printer will be ready for printing.
Sealing Strip
4.1. Toner Kit Replacement
4-3