KORG TRITON STUDIO music workstation - Manual (Page 184)

174
When “LFO Wave” is set to Random, the “Step” parameter uses a
random LFO cycle.
b: LFO Phase
Offsetting the left and right phases alters how modulation is
applied to the left and right channels, creating a swelling affect.
f: BPM, g: StepBase, g: Times
The width of an LFO step, or a cycle of random LFO, is obtained
by multiplying the length of a note ( … ) (selected for “Step-
Base”, in relation to the tempo specified in “BPM,” or the MIDI
Clock tempo if “BPM” is set to MIDI) by the number specified in
the “Times” parameter.
j: W/D
The effect sound’s phase will be reversed when you set this
parameter in the range of values from –Wet to –1:99.
011: St.Exct/Enhcr
(Stereo Exciter/Enhancer)
This effect is a combination of the Exciter, which adds a punch
to the sound and the Enhancer, which adds spread and pres-
ence.
a: Blend
This parameter sets the depth (intensity) of the Exciter effect. Pos-
itive values give a frequency pattern (to be emphasized) different
from negative values.
b: Point
This parameter sets the frequency to be emphasized. Higher val-
ues will emphasize lower frequencies.
c: Enh Dly L, d: Enh Dly R
These parameters set the delay time for the Enhancer left and
right channel. Specifying a slightly different delay time for the left
and right channel will add a stereo image, depth, and width to the
sound.
012: St.Sub OSC
(Stereo Sub Oscillator)
This effect adds very low frequencies to the input signal. It is
very useful when simulating a roaring drum sound or empha-
sizing powerful low range. This effect is different from the
equalizer in that you can add very low range harmonics. You
can also adjust the oscillator frequency to match a particular
note number, for use as an octaver.
a
Blend (Exciter Blend)
Sets the intensity (depth) of the Exciter effect –100...+100
☞
,
(Source) Off...Tempo
Selects the modulation source of the Exciter intensity
(Amount) –100...+100
Sets the modulation amount of the Exciter intensity
b
Point (Emphatic Point)
Sets the frequency to be emphasized 0...70
☞
,
(Source) Off...Tempo
Selects the modulation source of the frequency to be emphasized
(Amount) –70...+70
Sets the amount of modulation of the frequency to be emphasized
c
Enh Dly L (Enhancer Delay L)
Sets the delay time for the Enhancer left channel 0.0...50.0ms
☞
d
Enh Dly R (Enhancer Delay R) [msec] 0.0...50.0ms
Sets the delay time for the Enhancer right channel
☞
Random Filter LFO
LFO Step Freq
LFO Frequency
LFO Step Freq
Step-Tri Random
LFO Phase
0 +90 +180 [degree]
0 [degree] –90 –180
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
EQ Trim
LEQ HEQ
EQ Trim
Delay
Delay
Depth
D -mod
Exciter
Exciter
Enhancer
e
Enh Dep (Enhancer Depth) 0...100
Sets the determines to what degree the Enhancer effect is applied
(Source) Off...Tempo
Selects the modulation source of the Enhancer width
(Amount) –100...+100
Sets the modulation amount of the Enhancer width
f
Pre EQ Trim
Sets the EQ input level 0...100
g
LoEQ (Pre Low EQ Gain)
Sets the gain of Low EQ –15.0...+15.0dB
HiEQ (Pre High EQ Gain)
Sets the gain of High EQ –15.0...+15.0dB
h
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance –100...+100
a
OSC Mode Note (Key Follow), Fixed
Determines whether the oscillator frequency follows the note number
or whether it is fixed
☞
b
Note Interval –48...0
Sets the pitch difference from the note number when OSC
Mode=Note (Key Follow)
☞
c
Fine (Note Fine)
Fine adjustment of the oscillator frequency –100...+100
☞
d
Fixed (Fixed Frequency) 10.0...80.0Hz
Sets the oscillator frequency when OSC Mode=Fixed
(Source) Off...Tempo
Selects the modulation source for the oscillator frequency when OSC
Mode=Fixed
(Amount) –80...+80Hz
Sets the oscillator frequency modulation amount when OSC
Mode=Fixed
Stereo In - Stereo Out
D -mod
Envelope Sens
Envelope Shape
Response
Wet / Dry
Wah
Sweep Mode
D-mod
Auto
Left
Right
Wet / Dry
LFO
LFO
Wah
+