Dynamic modulation source (dmod), Dynamic modulation source list, Dynamic modulation source – KORG TRITON STUDIO music workstation User Manual

Page 237: Dmod), P.227, P.227), Appendices 227

Advertising

Appendices

227

You can control certain effect parameters using the joystick,
REAL TIME CONTROLS knobs, etc. “on the fly.” Control-
ling effects in this way is referred to as Dynamic Modula-
tion

. For example, you can use After Touch to speed up the

LFO of the chorus and flanger, or you can use the joystick to
activate the wah effect. In this way, you will be able to take
full advantage of the effects as part of the expressive poten-
tial of your instrument.
Most of the parameters for dynamic modulation consist of
parameter values for “(Source)” and “(Amount).” The
“(Source)” field selects the modulation source, and
“(Amount)” sets the amount of dynamic modulation effect.
When the modulation source is set to the maximum value,
the actual degree of the effect will be the parameter value
plus the “(Amount)” value.

Example:

“W/D (Wet/Dry)” 10:90, “(Source)” AfterT,

“(Amount)” +50

In this case, the effect balance is 10:90. As you apply After
Touch, the percentage of the effect sound will increase.

When After Touch is at its maximum, the effect balance will
be 60:40.

The dynamic modulation effect will not be affected if
you modify the “(Amount)” value while dynamic mod-
ulation is being applied. The change will become effec-
tive when you operate the dynamic modulation source
again.

Refer to the corresponding effect section for an explanation
of other dynamic modulation parameters.
In the table of parameters for each effect, dynamic modula-
tion parameters are marked by a

symbol at the right

of the parameter.

Dynamic Modulation Source List

CC#:

This is the control change number.

This indicates a controller or a function assigned to a controller on the TRITON/TRITONpro/TRITONproX. The con-
troller and the type of MIDI messages it transmits will depend on the type of connected MIDI instrument.

Dynamic Modulation Source

(Dmod)

Wet / Dry

Max

Zero

Higher

-mod

Dry

Wet

60:40

10:90

Dynamic Modulation (Example)

Wet / Dry=10:90
Amt= +50

Wet / Dry=60:40
Amt= –50

Source name

Explanation

Off

dynamic modulation is not used

Gate1

note on/off