Kathrein UFS 740sw - Manual (Page 22)

22
FIRST INSTALLATION: One cable (automatic)
The receiver searches for the transmission
channels on your single-cable system and shows
in the next display the available transmission
channels (transmission channels already in use
by other receivers are also displayed).
Use the

buttons to select the transmission
channel you want and confi rm the selection with the
button.
The receiver now reads the existing system data
for your single-cable system and confi gures
itself.
The receiver has been successfully registered on your
single-cable system. Confi rm the display with the
button. Now press the
!
(green) button. The receiver
will automatically display the menu for the channel
search. Continue with the section (Execute channel
search).
If no connection to the single-cable system could be established, you will receive the message “Registration
was abortive!”. Check your settings and if necessary call for expert help.
If one or more receivers are already present on the system and an additional receiver
is to be connected, when assigning the transmission frequency for the new receiver
make sure that no transmission frequencies are duplicated. No frequency
can be used by more than one receiver.
No frequency can be used by more
than one receiver.
The receivers would interfere with
each other.