Linksys SRW2016 - Manual (Page 36)

26 Chapter 5: Using the Web-based Utility for Configuration
Switch Conf. (Configuration) Tab - Interface Conf. (Configuration)
WebView Switches
PVE. For Gigabit Ethernet switches. When a port is a Private VLAN Edge (PVE) port, it bypasses the Forwarding
Database and forwards all unicast, multicast, and broadcast traffic to an uplink, except for MAC-to-me packets.
Uplinks can be ports or LAGs.
PVE. For Fast Ethernet switches. PVE Groups indicates the PVE group to which the port belongs. When an
uplink is configured for a port, all ports in that group are also protected by that uplink. PVE Uplink indicates the
uplink to which all traffic from a protected port is forwarded.
If you want to reset a port’s settings to its defaults, select a port by clicking the radio button for that port. Then,
click the Reset the settings of Selected Port to default button.
If you want to modify a port’s changes, select a port by clicking the radio button for that port. Then, click the
Modify the settings of Selected Port button. On the new screen that appears, you can change the port’s
settings. (Some settings shown may not be available, depending on the type of switch you have and other
settings you have configured for that port.)
Interface. This is the port number.
Description. Enter a description for this port.
Port Type. This is the port type.
Admin Status. Change the status of the port here.
Current Port Status. Displayed here is the status of the port.
Reactivate Suspended Port. If you want to reactivate a port that has been suspended, click the checkbox.
Operational Status. This indicates whether or not the port is active.
Admin Speed. Change the speed of the port here.
Current Port Speed. Displayed here is the current speed of the port.
Admin Duplex. Change the duplex mode here.
Current Duplex Mode. This is the duplex mode of the port.
Auto Negotiation. You can enable or disable the port’s Auto Negotiation feature.
Current Auto Negotiation. This is the current setting of the port’s Auto Negotiation feature.
Back Pressure. You can enable or disable the port’s Back Pressure feature.
Figure 5-9: Interface Configuration - Change Settings
NOTE: PVE is configured on a group of ports
for FE devices. This is done using the using the
PVE Mapping screen