Linksys SRW2016 - Manual (Page 66)

56 Chapter 5: Using the Web-based Utility for Configuration
SNTP Tab - Servers
WebView Switches
SNTP Tab - Servers
On the Servers screen, you can see a list of servers and their settings.
Unicast Server. Displayed here is the IP address of the unicast server.
Poll Interval. This is the interval (in seconds) at which the unicast server is polled for unicast information.
Encryption Key ID. This is the encryption key used to authenticate the unicast server and Switch.
Preference. This is the Switch’s preference for this particular unicast server.
Status. Displayed here is the status of the unicast server.
Last Response. This describes the last response of the unicast server.
Offset. This is the difference between the Switch’s time zone and the server’s time zone.
Delay. This shows how long it takes for data from the server to travel to the Switch.
Add icon. To add an SNTP server, click the paper and pencil icon. Configure its settings on the screen that
appears, as described below.
Anycast Server. Displayed here is the IP address of the anycast server.
Interface. This is the interface that the anycast server uses.
Preference. This is the Switch’s preference for this particular anycast server.
Status. Displayed here is the status of the anycast server.
Last Response. This describes the last response of the anycast server.
Offset. This is the difference between the Switch’s time zone and the server’s time zone.
Delay. This shows how long it takes for data from the server to travel to the Switch.
Broadcast Server. Displayed here is the IP address of the broadcast server.
Interface. This is the interface that the broadcast server uses.
Preference. This is the Switch’s preference for this particular broadcast server.
Figure 5-52: SNTP - Servers