Liebert Challenger ITR - Manual (Page 9)

Installation
3
2.4.1 Handling With Skid
• Always keep the Liebert Challenger ITR upright, indoors and protected from damage.
• Do not use the extended rear door frame to lift the unit.
• If possible, transport the unit using a fork lift; otherwise, use a crane with belts or cables, avoid-
ing pressing on the top edges of the packaging.
• If using a fork lift, make sure that the forks, if adjustable, are spread to the widest allowable dis-
tance to still fit under the skid.
NOTICE
Do not attempt to lift the Liebert Challenger ITR with the extended rear door frame.
Attempting to do so will damage the unit. Lift the unit only from its main base.
NOTICE
While on the skid, the Liebert Challenger ITR is too tall to fit through a standard height
doorway (83 inches or 2108 mm tall). Any attempt to move the unit, while on the skid,
through a standard doorway will damage the unit.
2.4.2 Removal of Skid
1. Remove the plywood skirting that keeps the skid and unit in place.
2. Raise the Liebert Challenger ITR off the skid. Liebert recommends using a fork lift (see Figure 1)
or similar machine to ensure that the unit is lifted properly.
3. Once the unit is raised, the skid can be removed.
Figure 1 Removing Liebert Challenger ITR from skid
NOTE
Lift the Liebert Challenger ITR only from its main base. Do not use the extended rear door
frame to lift the unit.
Table 1 Unit shipping weights
Model
Domestic Export
Model
Domestic Export
lb (kg) lb (kg) lb (kg) lb (kg)
50Hz Models 60Hz Models
BR059E 650 (295) 750 (340) BR060E 650 (295) 750 (340)
BR065A 745 (340) 845 (385) BR067A 745 (340) 845 (385)
BR070WG 815 (370) 915 (415) BR071WG 815 (370) 915 (415)
BM058G 855 (390) 955 (435) BM061G 855 (390) 955 (435)
BR101C 660 (300) 760 (345) BR102C 660 (300) 760 (345)
Remove plywood skirting holding
unit and skid in place.
Raise unit with fork lift
or similar machine.