Lenovo J SERIES 3000 - Manual (Page 57)

Diagnostic Error Code FRU/Action
005-199-XXX Video test failed, cause unknown 1. Go to “Undetermined problems” on page 67
2. Flash the system and re-test. See “Flash update
procedures” on page 185
3. Replace component under function test
005-2XX-XXX 005-3XX-XXX Video subsystem error 1. Video card, if installed
2. System board
006-000-XXX Diskette interface Test Passed No action
006-0XX-XXX Diskette interface error 1. Diskette drive Cable
2. Diskette drive
3. System board
006-195-XXX Diskette interface Test aborted by user Information only Re-start the test, if necessary
006-196-XXX Diskette interface test halt, error threshold
exceeded 1. Press F3 to review the log file
2. Re-start the test to reset the log file
006-197-XXX Diskette interface test warning 1. If a component is called out, make sure it is
connected and/or enabled
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
006-198-XXX Diskette interface test aborted 1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test. See “Flash update
procedures” on page 185
3. Go to “Undetermined problems” on page 67
006-199-XXX Diskette interface test failed, cause
unknown 1. Go to “Undetermined problems” on page 67
2. Flash the system and re-test
3. Replace component under function test
006-25X-XXX Diskette interface Error 1. Diskette drive cable
2. Diskette drive
3. System board
011-000-XXX Serial port Interface Test Passed No action
011-001-XXX Serial port Presence 1. Remove external serial device, if present
2. Run setup, enable port
3. System board
011-002-XXX 011-003-XXX Serial port Timeout/Parity
error System board
011-013-XXX 011-014-XXX Serial port Control
Signal/Loopback test failure System board
011-015-XXX Serial port External Loopback failure 1. Wrap plug
2. System board
Chapter 7 . Symptom-to-FRU Index 51