Lenovo J SERIES 3000 - Manual (Page 69)

Diagnostic Error Code FRU/Action
217-28X-XXX 217-29X-XXX Hard Disk Drive (SCSI) error 1. Hard Disk Drive Cable
2. Check power supply voltages
3. Reseat the hard disk drive cable
4. Hard Disk drive (SCSI)
5. SCSI adapter card
6. System board
220-000-XXX Hi-Capacity Cartridge Drive Test Passed No action
220-XXX-XXX Hi-Capacity Cartridge Drive error 1. Remove the Hi-Capacity Cartridge Drive and
re-test the system
301-XXX-XXX Keyboard error 1. Keyboard
2. Check and test mouse
3. System board
301-000-XXX Keyboard Test Passed No action
302-000-XXX Mouse Test Passed No action
302-XXX-XXX Mouse error 1. Mouse
2. Check and test Keyboard
3. System board
303-000-XXX Joystick Test Passed No action
303-XXX-XXX Joystick error Remove the Joystick and re-test the system
305-000-XXX Monitor DDC Test Passed No action
305-250-XXX Monitor DDC self test failure 1. Run Setup to enable DDC
2. Cable
3. Monitor
4. Video card
5. System board
415-000-XXXModem Test Passed No action
415-XXX-XXX Modem error Remove the Modem and re-test the system
Beep symptoms
Beep symptoms are tones or a series of tones separated by pauses (intervals without sound) during POST.
The following table describes beep symptoms.
Beep Symptom FRU/Action
2 short beeps CMOS setting error Perform the following actions in order.
1. Start the Setup Utility program and press F10 to
Save and exit. See Chapter 6 “Diagnostics, Test and
Recovery Information” on page 41.
2. Start the Setup Utility program and press F7 to load
defaults and then press F10 to Save and exit.
3. Perform a Boot block recovery. See “Recovering from
a POST/BIOS update failure” on page 186.
Chapter 7 . Symptom-to-FRU Index 63