Lenovo J SERIES 3000 - Manual (Page 61)

Diagnostic Error Code FRU/Action
018-199-XXX PCI Card test failed, cause unknown 1. Go to “Undetermined problems” on page 67
2. Flash the system and re-test. See “Flash update
procedures” on page 185
3. Replace component under function test
018-250-XXX PCI Card Services error 1. PCI card
2. Riser card, if installed
3. System board
020-000-XXX PCI Interface Test Passed No action
020-0XX-XXX PCI Interface error 1. PCI card
2. Riser card, if installed
3. System board
020-195-XXX PCI Test aborted by user Information only Re-start the test, if necessary
020-196-XXX PCI test halt, error threshold exceeded 1. Press F3 to review the log file
2. Re-start the test to reset the log file
020-197-XXX PCI test warning 1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
020-198-XXX PCI test aborted 1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Flash the system and re-test. See “Flash update
procedures” on page 185
3. Go to “Undetermined problems” on page 67
020-199-XXX PCI test failed, cause unknown 1. Go to “Undetermined problems” on page 67
2. Flash the system and re-test. See “Flash update
procedures” on page 185
3. Replace component under function test
020-262-XXXPCI system error 1. PCI card
2. Riser card, if installed
3. System board
025-000-XXXIDE interface Test Passed No action
025-00X-XXX 025-01X-XXX IDE interface failure 1. IDE signal cable
2. Check power supply voltages
3. Reseat IDE signal cable
4. IDE device
5. System board
Chapter 7 . Symptom-to-FRU Index 55