Lenovo J SERIES 3000 User Manual
Page 60
Diagnostic Error Code
FRU/Action
015-195-XXX USB port Test aborted by user
Information only Re-start the test, if necessary
015-196-XXX USB port test halt, error threshold exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
015-197-XXX USB port test warning
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
015-198-XXX USB port test aborted
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Flash the system and re-test. See “Flash update
3. Go to “Undetermined problems” on page 67
015-199-XXX USB port test failed, cause unknown
1. Go to “Undetermined problems” on page 67
2. Flash the system and re-test. See “Flash update
3. Replace component under function test
018-000-XXX PCI Card Test Passed
No action
018-0XX-XXX PCI Card Failure
1. Riser card, if installed
2. System board
018-195-XXX PCI Card Test aborted by user
1. PCI card
2. Information only Re-start the test, if necessary
018-196-XXX PCI Card test halt, error threshold exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
018-197-XXX PCI Card test warning
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
018-198-XXX PCI Card test aborted
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Flash the system and re-test. See “Flash update
3. Go to “Undetermined problems” on page 67
54
Hardware Maintenance Manual Lenovo 3000 J Series