Lenovo J SERIES 3000 User Manual
Page 64
Diagnostic Error Code
FRU/Action
035-198-XXX RAID interface test aborted
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Flash the system and re-test. See “Flash update
3. Go to “Undetermined problems” on page 67
035-199-XXX RAID interface test failed, cause unknown
1. See “Undetermined problems” on page 67
2. Flash the system and re-test. See “Flash update
3. Replace component under function test
071-000-XXX Audio port Interface Test Passed
No action
071-00X-XXX 071-01X-XXX 071-02X-XXXAudio port
error
1. Run Setup
2. Flash the system. See “Flash update procedures” on
3. System board
071-03X-XXX Audio port failure
1. Speakers
2. Microphone
3. Audio card, if installed
4. System board
071-04X-XXX Audio port failure
1. Run Setup
2. Audio card, if installed
3. System board
071-195-XXX Audio port Test aborted by user
Information only Re-start the test, if necessary
071-196-XXX Audio port test halt, error threshold
exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
071-197-XXX Audio port test warning
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
071-198-XXX Audio port test aborted
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Flash the system and re-test. See “Flash update
3. Go to “Undetermined problems” on page 67
071-199-XXX Audio port test failed, cause unknown
1. See “Undetermined problems” on page 67
2. Flash the system and re-test. See “Flash update
3. Replace component under function test
58
Hardware Maintenance Manual Lenovo 3000 J Series