Pantech Matrix Pro - Manual (Page 239)

237 Chapter 16. Safety and warranty
Read this information before using your Handheld Portable
Cellular Telephone.
EXPOSURE TO RADIO FREQUENCY SIGNALS
Your wireless handheld portable telephone is a low power radio
transmitter and receiver. When it is ON, it receives and also sends out
radio frequency (RF) signals.
In August 1996, the Federal Communications Commissions (FCC)
adopted RF exposure guidelines with safety levels for handheld wireless
phones. Those guidelines are consistent with the safety standards
previously set by both U.S. and international standards bodies:
• ANSI C95.1 (1992) *
• NCRP Report 86 (1986) *
• ICNIRP (1996) *
Those standards were based on comprehensive and periodic
evaluations of the relevant scientific literature. For example, over 120
scientists, engineers, and physicians from universities, government
health agencies, and industry reviewed the available body of research to
develop the ANSI Standard (C951).
The design of your phone complies with the FCC guidelines (and those
standards).
ANTENNA CARE
Use only the supplied or an approved replacement antenna.
Unauthorized antennas, modifications, or attachments could damage the
phone and may violate FCC regulations.
SAFETY INFORMATION FOR WIRELESS
HANDHELD PHONES
1*: American National Standards Institute.
2*: National Council on Radiation protection and measurements.
3*: International Commission on Non-ionizing Radiation Protection.