Speaker setting, Advanced operations, Changing settings – Panasonic DVD-H2000 User Manual
Page 33: Action, Speaker presence and size ( = ), Delay time ( > ), Channel balance ( ? )
33
Advanced operations
RQT5741
B
LS
RS
L
R
SW
f
e
d
C
LS
SUBTITLE
TV
CH
TV/AV
GROUP
PAGE
SKIP
STOP
1
2
3
4
5
6
PAUSE
PLAY
SLOW/SEARCH
AUDIO
RETURN
MARKER
VOL
POWER
POWER OPEN/CLOSE
T
C
E
R
I
D
R
O
T
A
G
I
V
A
N
TO
P
M
EN
U
M
E
N
U
DISPLAY
T
SI
L
Y
A
L
P
ENTER
A
LS
ACTION
SELECT
ENTER RETURN
m s
m s
d B
0
d B
d B
L
Exit
Test
LS
R
SW
C
RS
d B
0
0
0
0
0
b a c
a
a
(L)
a (L)c b (R)c (R)a
c a
Changing settings
Speaker setting
[DVD-A] [DVD-V]
Change speaker size and presence
=, delay time >, and channel
balance
? to suit the speakers you have connected.
These settings are not necessary when you select “2-channel”
(only two speakers are connected).
»
A
Speaker presence and size (
=)
1. Use the joystick [
3,4,2, 1] to select the item and press
[ENTER].
2. Move the joystick [
3,4] to select the setting and press
[ENTER].
Icon examples: Surround speaker (L)
[A]
Large: When the speaker supports low-frequency (under 100 Hz)
reproduction.
Small: Select when the speaker does not support low-frequency re-
production.
The size setting for the front speakers is automatically determined
by the setting for the subwoofer.
»
B
Delay time (
>)
[DVD-V] (Dolby Digital, center and surround speakers only)
For optimum listening with 5.1-channel sound, all the speakers, ex-
cept for the subwoofer, should be the same distance from the seat-
ing position. If you have to place the center or surround speakers
closer to the seating position, adjust the delay time to make up for
the difference.
If distance
@ (from the center speaker) and B (from the surround
speakers) are the same as or greater than
A (from the front speak-
ers), leave the delay time as “0”, the factory preset.
If either distance
@ or B is less than A, find the difference in the
relevant table and change to the recommended setting.
Changing the delay time
1. Use the joystick [
3, 4, 2, 1] to select the delay time box
and press [ENTER].
2. Move the joystick [
3, 4] to adjust the delay time and press
[ENTER].
Channel balance (
?)
1. Use the joystick [
3, 4, 2, 1] to select “Test” and press
[ENTER].
A test signal is output from one speaker at a time, starting with
the front left speaker and proceeding clockwise.
FRONT (L)
_--)CENTER_--)FRONT (R)
e
v
SURROUND (L)
(-------------==SURROUND (R)
2. While listening to the test signal, move the joystick [
3, 4]
to adjust the volume of the center and surround speakers so
they are the same apparent volume as the front speakers.
(The front speakers cannot be adjusted here.)
3. Press [ENTER].
The test signal stops.
Note
No signal is output for the subwoofer. To adjust its volume, play
something, then return to this screen to adjust to suit your taste.
When you are finished
Use the joystick [
3, 4, 2, 1] to select “Exit” and press [ENTER].
Note
The unit may be unable to output as set here due to limitations im-
posed by the unit itself or the disc being played. (The FL display’s
“P.PCM” indicator lights or “D.MIX” indicator goes out in these
cases.)
No
Large
Small
Joystick/
ENTER
Difference
Approx. 200 cm (6 feet)
Approx. 400 cm (12 feet)
Approx. 600 cm (18 feet)
Setting
5.3 ms
10.6 ms
15.9 ms
Difference
Approx. 50 cm (1
1
/
2
feet)
Approx. 100 cm (3 feet)
Approx. 150 cm (5 feet)
Approx. 200 cm (6 feet)
Setting
1.3 ms
2.6 ms
3.9 ms
5.3 ms
³Center speaker
³Surround speakers
Front (L)
Center
Front (R)
Test
signal
Exit
Surround
Subwoofer