Panasonic DVD-H2000 - Manual (Page 38)

Reference
RQT5741
38
No response when buttons
pressed.
No operations can be performed
with the remote control or the
professional commander.
The remote control cannot
operate the television.
Play fails to start even when
[
1] (play) is pressed.
Play starts but then stops
immediately.
Alternative languages fail to be
selected.
No subtitles.
Soundtrack and/or subtitle
language is not the one selected
with the ACTION menus.
Angle cannot be changed.
You have forgotten your ratings
password.
Reset all the settings to Factory
Preset.
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do
not solve the problem:
In the U.S.A., contact the Panasonic Customer Call Center at 1-800-211-7262, or e-mail [email protected], or
web site (http://www.panasonic.com).
In Canada, contact Panasonic Canada Inc. Customer Care Centre at 1-800-561-5505, web site (www. panasonic.ca), or an authorized
Servicentre closest to you.
Reference pages are shown as black circled numbers :.
Power
³Some operations may be prohibited by the disc.
³The unit may not be operating properly due to lightning, static electricity or some other external
factor.
Reset procedure:
Press [POWER,
ê/I] to switch the unit to the standby mode and then back to ON.
Alternatively, press [POWER, ê/I] to switch the unit to the standby mode, disconnect the AC
power supply cord, and then reconnect it.
³Check the batteries are installed correctly. 9
³The batteries are depleted: Replace them with new ones. 9
³Point the remote control or the professional commander at the remote control sensor and
operate. 9
³Change the manufacturer code. The remote control is unable to operate some types of
televisions. C
³Condensation has formed: Wait 1 to 2 hours for it to evaporate.
³This unit cannot play discs other than DVD-RAM, DVD-Audio, DVD-Video, Video CD and CD. 6
³This unit cannot play DVD-Video with a region number other than “1”, “ALL” or multiple region
numbers including “1”. 6
³The disc may be dirty and may require cleaning. X
³Ensure that the disc is installed with the label of the side to be played facing upwards. <
³Check that the DVD-RAM has something recorded on it.
³An alternative language is not selected with discs which do not contain more than one language.
³In the case of some discs, the alternative language cannot be selected with [AUDIO] or
[SUBTITLE]. Try selecting it from the disc’s menu if one is available. =
³Subtitles appear only with discs that contain them.
³Subtitles are cleared from the television. Display the subtitles. H
³The language is not recorded on the disc.
³This function is dependent on software availability. Even if a disc has a number of angles
recorded, these angles may be recorded for specific scenes only. H
³While stopped, press and hold [:] and [;] on the unit and then also press and hold [<] on the
unit until “Initialized” disappears from the television. Turn the unit off and on again.
All settings will return to the default values.
³Insert the AC power supply cord securely into the household AC outlet. :
³To conserve power, the unit automatically switches to standby after approximately 30 minutes in
the stop mode. Turn the power back to ON.
[You can use the ACTION menus (Others—Auto Power Off) to turn this feature off if you would
prefer.
O]
Operation
No power.
The unit is automatically switched
to the standby mode.
Troubleshooting guide