Panasonic PT-D7600U User Manual
Page 11
11
USER button
Displays the sub-memory screen of the signal
registration.
LIGHT button (
Click button)
When this button is pressed, the remote control
button light is turned on.The light goes off about 30
seconds after you stop remote control operation.
ID ALL button (page 16,70)
When two or more main units are used in the
system, this button switches to the mode to control
them simultaneously with a single remote control.
ID SET button (page 16,70)
When two or more main units are used in the
system, this button specifies the ID of the remote
control.
Remote control wired terminal (page 17)
To use the wired output terminal, connect the
remote control and the main unit with the supplied
cable.
Remote control transmitter window
Operate the remote control aiming at the remote
control receiver window on the main unit.
P A
GE
D
OW
N
LA
SE
R O
N/O
FF
P A
GE
P A
GE
PO
W
ER
ON
OF
F
RG
B
1
RG
B
2
AU
X
MENU
ENTE
R
P A
GE
U
P
VIDEO
SHUT
S-
VID
EO
FR
EE
ZE
SHUTTER
AU
TO
SE
TU
P
ST
D
LE
NS
OS
D
1
4
7
2
5
8
3
6
9
0
NE
XT
USER
LIG
HT
ID A
LL
ID S
ET
Pro
jec
to
r
Computer
Nu
me
tric
BRIGHT
CO
NT
RA
ST
ON
S
CR
EE
N
SY
ST
EM
SEL
FU
NC
1
D.
ZOOM
ASPECT
POWER
ON
OFF
RGB
1
RGB
2
AUX
MENU
STD
LENS
OSD
1
4
7
2
5
8
3
6
9
0
NEXT
USER
LIGHT
ID ALL
ASPECT
ID SET
Projector
Computer
Numetric
BRIGHT
CONTRAST
ON SCREEN
SYSTEM
SEL
FUNC
1
D.ZOOM
ENTER
PAGE
UP
PAGE
DOWN
VIDEO
SHUT
S-
VIDEO
FREEZE
SHUTTER
AUTO
SETUP
LASER ON/OFF
<When the operation mode selector
is
set to Computer>
ENTER button
Moves the mouse cursor.
(
) buttons
These buttons correspond to the left and right
mouse buttons.
PAGE UP/PAGE DOWN buttons
These buttons correspond to the PAGE UP/PAGE
DOWN buttons on PC's keyboard.
Numeric (0-9) button
In a system that uses two or more units of this
projector or in a system that connects to an
optional signal selector, these buttons specify a
particular projector unit or the input of the signal
selector. They are also used to enter ID numbers
when selecting the ID or to enter specific numbers
when entering a password.
Operation mode selector (Computer/Numeric,
Projector) switch (page 17)
Put this selector to the right position to control the
projector and to the left position to control the PC
or use numeric buttons.
Click button (page 17)
This button corresponds to the left mouse button
when the operation mode is switched to the
Computer position.
• To use the remote control as a mouse,
please purchase an optional wireless
mouse receiver (model No.: ET-RMRC1).
• The AUX button to switch the input is
disabled when an optional input module is
not connected.
Note