Panasonic PT-D7600U - Manual (Page 81)

81
Using the REMOTE 2 terminal provided on the side of the main unit, it is possible to operate the projector from a
control panel etc. furnished in a distant location where infrared remote control signal cannot be received.
Pin assignments and control
Be sure to short-circuit Pins and when controlling.
D-Sub 9-pin (female)
external appearance
Note
Example of a control panel layout
Projector set up in a meeting room
Control panel located in a different room
STANDBY ON
VIDEO/S-VIDEO
S-VIDEO
RGB2
RGB
VIDEO
RGB1
LAMP
Remote terminal External control
Remote terminal/External control
RGB/VIDEO
INPUT SELECT
Using the REMOTE 2 terminal
Names of terminals
GND
POWER
RGB1
RGB2
VIDEO
S-VIDEO
AUX
SHUTTER
RST / SET
Open (H)
Controlled by remote control
OFF
Other
OFF
Short (L)
Controlled by external contact
ON
AUX
S-VIDEO
VIDEO
RGB2
RGB1
ON
GND
9
1
2
4
5
6
7
8
3 Other
Other
Other
Other
• The “POWER”, “RGB” and “VIDEO” buttons on the remote control and projector will not operate
when pins and are shorted. In addition, it disables the main unit operation sections that
correspond to those functions, remote control buttons and RS-232C commands.