Panasonic PT-D7600U - Manual (Page 73)

73
System information
Displays the system information of the projector.
• Pressing the “ENTER” button will move on to the next
page.
Automatic adjustment
(Only for RGB input)
Use this setting when adjusting a specific or oblong
(16:9, etc.) signal.
Press the MENU button.
The MAIN MENU screen will be displayed.
Select “OPTION” with the
buttons.
Press the ENTER button.
The OPTION screen will be displayed.
Using the buttons, select “AUTO
SETUP”.
Press the buttons.
The AUTO SETUP screen will be displayed.
Using the buttons, switch to the
desired mode.
“STANDARD”: to receive signals of which
image aspect is 4:3 or 5:4
“WIDE”: to receive signals of which
image aspect is 16:9 (oblong)
“USER”: to receive signals of specific
horizontal resolution (number of
horizontally displayed dots)
If “USER” is selected, enter the
horizontal resolution of signal source
into “number of horizontally displayed
dots” using
buttons.
Press the ENTER button.
Execute automatic adjustment.
A message “EXECUTING...” appears during
automatic adjustment.
When the adjustment is complete, the system
returns to the input screen.
MODE
STANDARD
WIDE
Applicable resolution
640 x 400, 640 x 480, 800 x 600, 832 x
624, 960 x 720, 1 024 x 768, 1 152 x 864,
1 152 x 870, 1 280 x 960, 1 280 x 1 024,
1 600 x 1 200
720 x 400, 848 x 480, 1 280 x 720,
1 120 x 750, 1 376 x 768, 1 600 x 1 024
Video setting
This feature allows the user to select the signaling
system according to the connected device.
Select “VIDEO SETTING” from the
“OPTION” screen and press the ENTER
button.
The “VIDEO SYSTEM” screen will be displayed.
Use the buttons to select “AUTO
1” or “AUTO 2”.
VIDEO SYSTEM AUTO 1
AUTO 2
SYSTEM INFORMATION
ROM VERSION:
1.00
SET RUNTIME: 14h
LAMP1 RUNTIME: 13h
LAMP2 RUNTIME: 13h
INPUT BOARD: NOT YET
NUMBER OF
ENTRY SIGNAL:
4/96
ENTER: NEXT
SYSTEM INFORMATION
ROM VERSION:
1.00
ON COUNT
POWER ON TIMES: 55
LAMP 1 ON: 57( 0)
LAMP 2 ON: 59( 0)
AUX: NOT YET
NUMBER OF
ENTRY SIGNAL:
4/96
ENTER: NEXT
“AUTO1”: The system is automatically selected from
among NTSC, PAL, SECAM, NTSC4.43 and
PAL60.
“AUTO2”: The system is automatically selected from
among NTSC, PAL-M and PAL-N.
Note
• When ET-MD95VM2 (optional) is
mounted, an item of “VIDEO SELECT” will
appear on the “VIDEO SETTING” screen
allowing the used to select either “LINE or
Y/C” or “YC
b C r ”.
Fan control
When using the projector over 1 400 m (4605.3')
above sea level, set to “High”.
FAN CONTROL NORMAL
HIGH