Panasonic PT-D7600U - Manual (Page 45)

45
If new registration is not available because of full memory:
If the number of already registered signals is 96, or the memory is full when you entered a new signal, then press the
MENU button of the remote control or the operating section of the main unit, and a “Confirm overwriting registration”
screen appears. This means to erase registered signal and to register a new signal by overwriting. In this case,
erase the registered signal and register a new signal by overwriting using the following Steps
to :
Press the “MENU” button.
The “Confirm overwriting registration” screen will
be displayed.
Press the ENTER button.
The SIGNAL LIST screen will be displayed. The
memory list contains 96 data items on its 12 pages
(8 each on A to L pages).
Select the signal to erase with the ,
, and buttons.
Press the ENTER button.
The SIGNAL STATUS screen will be displayed.
If you do not want to erase, press the MENU
button to return to the “SIGNAL LIST” screen.
Press the ENTER button.
This erases the signal selected in Step and the
“SIGNAL STATUS” screen for the overwritten
signal appears. In each item, automatically
identified content of the new signal is displayed.
Further Steps are the same as Step
on page 44.
MEMORY FULL
OVERWRITE?
NAME:
MEMORY NO:
– –
S.S.NO: – – –
INPUT NO: VIDEO
fH: 15.73kHz
fV: 59.94Hz
FORMAT: NTSC
ENTER:EXECUTE MENU:ESC
SELECT OVERWRITE SIGNAL.
A1:SVGA72-A1 RGB1 – – –
A2:SVGA72-A2 RGB1 – – –
A3:SVGA72-A3 RGB1 – – –
A4:SVGA72-A4 RGB1 – – –
A5:SVGA72-A5 RGB1 – – –
A6:SVGA72-A6 RGB1 – – –
A7:SVGA72-A7 RGB1 – – –
A8:SVGA72-A8 RGB1 – – –
:SELECT ENTER:SET
OVERWRITE THIS SIGNAL.
NAME: SVGA72-A3
MEMORY NO: A3(3-2)
S.S.NO: – – –
INPUT NO: RGB1
fH: 48.08kHz
fV: 72.17Hz
SYNC. STATE: H(POS)
V(POS)
ENTER:EXECUTE MENU:ESC