Panasonic KX-TG5240AL - Manual (Page 17)

Useful Info
rmation
Answering
System
T
e
lephone System
17
Programmable Settings
Preparatio
n
Date and Time
You need to set the date and time to announce the day and time when each
message was recorded, during a message playback.
• When entering the time, you cannot enter numbers greater than 12. Do not use
military time. (To set 13:00 hours, enter “0100”, and select “PM” in step 4. )
To confirm the date and time, repeat steps 1 and 2 above.
• The current date and time are displayed. When finished, press [OFF].
1 Press [MENU].
2 Scroll to “Date and time” by pressing [d]
or [B], then press the soft key ( ).
3 (1) Enter 2 digits each for the day, month and
year. (Ex. To set May 15, 2004, enter
“15 05 04”.)
(2) Enter 4 digits for the time (hour and
minute). (Ex. To set 9:30, enter “0930”.)
• If you enter a wrong number, press the soft key
( ) or ( ), or press [B] or [d] to move
the cursor to the incorrect number. Enter the
correct number.
4 Select “AM” or “PM” by pressing [*].
5 Press the soft key ( ).
• The date and time are set and “ E ” disappears from the base unit display.
• If the handset beeps 3 times, the date and time were not set correctly. Start
again from step 3.
6 Press [OFF].
The date and time may be incorrect after a power failure. When “ E ” flashes on
the base unit display, set the date and time again.
For Caller ID service users (p. 34)
• When a call is received, Caller ID information adjusts the date and time if the
time is incorrect.
• Caller ID information will automatically adjust the date and time for daylight
saving time.
• If the date and time have not been previously set, Caller ID information will not
adjust the date and time.
Handset
SELECT
B
Date and time
d
BACK PLAY SELECT
f g
Date: | 31.12.2004
Time:12:00 AM
0-9=Date&Time
@=AM/PM
f g SAVE
Date: | 15.05.2004
Time:09:30 AM
0-9=Date&Time
@=AM/PM
f g SAVE
SAVE
TG5240AL.fm Page 17 Friday, June 11, 2004 5:22 PM