Panasonic KX-TG5240AL - Manual (Page 19)

Useful Info
rmation
Answering
System
T
e
lephone System
19
Programmable Settings
Preparatio
n
Base unit ringer volume
Make sure the base unit is not being used.
To set the ringer volume to high (preset), medium, or low, press [d] or [B].
• To increase volume, press [B]. To decrease volume, press [d].
• To stop ringing, press [STOP].
To turn the ringer off, press and hold [d] until 2 beeps sound.
• “ ” is displayed.
To turn the ringer on, press [d] or [B].
• The base unit will ring at the low level.
• You can adjust the ringer volume while an outside call is ringing.
Press [d] or [B] while the base unit is ringing.
To turn the ringer off, press and hold [d] until 2 beeps sound. “
” is displayed.
Ringer Tone
You can set the handset and base unit ringers to use one of 7 ringer patterns for
outside calls. “Tone 1” to “Tone 3” are bell ringer patterns. “Melody 1” to “Melody 4”
are melody patterns. The factory preset is “Tone 1”.
• You cannot change the ringer tone for intercom calls.
• If you select one of the melody ringer patterns, the ringer will continue to sound for
several seconds if:
— the caller hangs up before you answer the call, or
— another person answers the call using another phone connected on the same line.
Handset ringer tone
1 Press [MENU].
2 Press the soft key ( ) at “Ringer
setting”.
3 Scroll to “Ringer tone” by pressing [d] or
[B], then press the soft key ( ).
4 Select the desired ringer tone by pressing
[d] or [B].
• The handset will ring and the ringer tone will
change. If the ringer volume has been turned off,
the handset will not ring (p. 18).
• You can also select the ringer tone by pressing
[1] to [7].
5 Press the soft key ( ), then press [OFF].
Base Unit
RINGER
OFF
RINGER
OFF
Handset
SELECT Ringer setting
SELECT
Ringer tone
Ringer tone
1:Tone 1
SAVE
TG5240AL.fm Page 19 Friday, June 11, 2004 5:22 PM