Panasonic KX-TG5240AL - Manual (Page 93)

Useful Info
rmation
Answering
System
Preparatio
n
93
Troubleshooting
T
e
lephone System
General
Problem Cause & Remedy
The handset and/or base unit
does not work. • Check the settings (p. 12–14).
• Fully charge the battery (p. 13).
• Clean the charge contacts and charge again
(p. 14).
• Check battery installation (p. 13).
• Unplug the base unit’s AC adaptor to reset it.
Plug in, and try again.
• The handset has not been registered to the
base unit. Register the handset (p. 84, steps 5
and 6).
• Re-install the battery (p. 13) and fully charge it.
• KX-TG5240AL is not designed to be used
with rotary (pulse dialling) services.
“ E ” flashes on the base unit
display.
• If a power failure occurs, the date and time
setting may be erased. Set the date and time
again (p. 17).
“Recharge battery” is
displayed, “
3 ” flashes,
or the handset beeps
intermittently.
• Fully charge the battery (p. 13).
“Charge for 6 HRS” and
“
4 ” are displayed and the
handset does not work.
• The battery has been discharged. Fully
charge the battery (p. 14).
You charged the battery fully,
but “Recharge battery” is
still displayed and/or “
3 ”
continues to flash, or “Charge
for 6 HRS” and “
4 ” are
displayed.
• Clean the charge contacts and charge again
(p. 14).
• The battery may need to be replaced. If you
install a new battery, fully charge it (p. 13, 14).
The CHARGE indicator does
not go out after the battery has
been charged. • This is normal.
Panasonic Australia operates a toll free Customer Support Centre.
Please phone Panasonic on 132600 for assistance.
TG5240AL.fm Page 93 Friday, June 11, 2004 5:22 PM